How to choose wall decoration materials

[qizhen111]

<p>empty brick corners If there is an empty drum in the corner of the wall brick, we can first scrape the tile gap of the hollow corner, then inject the relatively thin cement mortar into it, and need to beat the tile when pouring, so that the cement can penetrate completely. This treatment method saves time and effort, and it is not easy to cause damage to the tile. How to deal with the empty brick wall: the middle part of the tile If there is an empty drum in the middle of the tile, it is best to use a suction cup to suck the tile, then suck it straight out, and then re-lay it through the empty tile. How to deal with wall tiles: large-area empty drums If more than one-third of the tiles on the wall are empty, then the tiles on the entire wall need to be knocked out and re-paved.</p> <p> The situation of empty drums is usually caused by improper construction. There should be a construction party to bear the cost of re-paving the wall. How to deal with the empty brick wall: empty drum If the wall tile is more serious and there is a situation of falling off, it means that the cement mortar under the tile and the base layer of the wall are loose. We can use a blade to clean the surface of the cement mortar, and then re-apply the cement for paving.</p> <p> It should be noted that if the tile is only partially peeled off, it should not be used to beat the mortar on the base of the wall. The solid tiles around are loose. How to deal with the empty brick wall: the degree is lighter and the position is more biased. If the wall surface only shows some relatively slight hollowing phenomenon, and the position is relatively quiet, it will not affect the installation of cabinets, mirrors and water heaters. Not bad, it has too much impact, and it can be left unprocessed.</p>